Scale Model Wood Effect Tutorial: Easy Step-by-Step Guide

Here is a short tutorial written and created by Marko Baric, explaining how to replicate a realistic wood finish on a scale model.

Imiter du bois - pièce non peinte


Step 1

Paint the part with acrylics. The shade should be beige or a similar color; the exact hue is not critical. Let it dry for at least two hours.

Step 2

Prepare your oil paint “mixture”.
Sienna + Rose Madder (Alizarin Crimson) + Cadmium Yellow.
The proportions? At your own discretion, depending on the type of wood you want to replicate. In my case, I prefer light wood, so I use more yellow than red and brown.

Les peintures nécessaires pour imiter du bois

Step 3

Using a wide dry brush (size P1), smooth your oil paint “mixture” over the part, spreading it thoroughly. Figure painters often refer to this action as “pulling” or “feathering” the paint. Remember to wipe your brush on a paper towel from time to time to remove any excess paint buildup.

Step 4

Take some Burnt Sienna (a near-black brown). Personally, I use Winsor & Newton. Using a triple-zero (000) brush, draw fine, scattered lines across the surface to simulate the wood grain.

 

Step 5

Now, take a third dry brush, size No. 2 (P3). Blend your Burnt Sienna lines into the base “mixture” layer by lightly sweeping the brush over those same lines, following the direction of the grain.

Once again, remember to wipe your brush regularly and maintain a light touch.

Using the P1 brush, lightly go over the surface one more time to further soften and blend the wood grain. If necessary, add a few more touches of Burnt Sienna and repeat steps 4 and 5 until you are satisfied with the result.

 

Step 6

Using the P3 brush, add a few dots of pure Cadmium Yellow.

 

Step 7

Using the same P3 brush, spread and blend the yellow into the previous shades.

Step 8

To finish, lightly go over the entire surface with the P1 brush, making sure it has been thoroughly cleaned with a paper towel.

 

Step 9

After letting it dry for 48 hours, apply one or two generous coats of gloss varnish (Klir or Future will do the job perfectly).
Important note: Everything I have just described might seem complicated. But give it a try and you will see it is child’s play, and above all, quick.

By Marko Baric